peugeot malossi PHBG intake - with fins
peugeot malossi PHBG intake - with fins
 
  $15.99

 :HERE NOW!!

qty:

 
 
peugeot moped malossi phbg intake with fins for phbg dellorto carburators.

this model creates some venturi by going from a 18.5mm ID down to a 15mm ID before reaching the reeds. measures about 70mm total length and 36mm total height.

uses your stock reeds still whist allowing you to put on a much larger carb. if you prefer you can go with the sha intake and use a smaller dellorto carb. ideally with a 65-75cc kit you want to be using a 19-21 phbg carb for max all around power.

02 2083B

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
3 of 5 On par with the polini one. July 26, 2018
taco eater : Jonathan Feldman from Portland, OR United States  
Significantly better casting on this guy than the polini guy.
Also looks like it might have a hairrrrrrr better clearance.

However it doesn't have that little cutout in the bottom for the reed block bolts to stick into. You'll need to make sure yo shit is FLAT AS FUCK / run a thick gasket / maybe cut this indentation yourself with a dremel?

Just like the other guy, not plug n play. Although this one is a lil prettier on the eyes and slightly cheaper.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 my mikuni likes this intake August 2, 2010
taco eater : french moped kisser from savannah, GA United States  
yes indeed! you can stick a small clamp mount mikuni on these. i have a vm16 on mine. i think vm20s and bigger are different. but 16 and maybe 18 fit. rquires some cleanup as most malossi intakes do. opening boltholes, sanding the mating surfaces flat. but totally good overall. and the fins -definitely- make it faster.

Was this review helpful to you?