taco eater :
Edward Manhart from Omaha, NE United States
Ok, this is a solid mounting pipe for your slutty French mopad, of course it’s going to break at some point. You knew that already. Get your homeboy to weld it up for ya! I’m running this on a highly ported stock Derbi. Starts top hit in the mid and continues to pull hard from there, to 11k on my stock cylinder!
Was this review helpful to you?
0 taco eaters like this review
does good things, but not great
July 8, 2015
taco eater :
Peter Notarangelo from Charlotte , NC United States
OK a real review. Typical polini product, can be VERY fast as its def a mid/high pipe, that clears pedals and stand!!
BUT its 18GA steel which means it will rip through in a very short amount of time(1-2 weeks) also comes with adaptors that all SLIP together, which leak and rattle it self apart. SO you can do like me and weld it all together, and like its cousin the circuit pipe, over and over again!
Also ground clearance is bad, like most frenchy pipes, in my case like 2.5" which is bad when the wall of the pipe will tear through like cold butter.
Was this review helpful to you?
0 taco eaters like this review
holy shit!
March 27, 2015
taco eater :
marcus from Smith's, Bermuda
I am running a polini 50 W-exhaust port, polini 4 petal race cases, Doppler crank, er3 vario, and pvl inner rotor. I thought the pipe was going to be too big for the 50 cylinder, but damn was I wrong. powerband is stronger than the polini mini circuit. 67mph on the radar gun (first run 62mph, second 67mph, third 64). so far fastest project ive ever set up. same thing as the other review, mounting bracket is at a weird angle with the polini spring, but nothing a quick weld couldn't fix. wish I had better brakes to slow down. oh well. clears pedals and kick stand too! couldn't ask for better service from treats either!
Was this review helpful to you?
0 taco eaters like this review
nice pipe
December 26, 2014
taco eater :
Ezel from Austin, TX United States
paired with a full polini 70cc motor and 15mm carb, it pulls nice in the mid to high range. probably wants a bigger carb tho... clears everything but the rear bracket is about a 1/2" too far back and puts the swivel bracket at a weird angle if you are running the polini spring. sounds good. this is on a '80 pug 103
Rips dicks 
does good things, but not great 
nice pipe