taco eater :
Jacob Fulton from Minneapolis, MN United States
I have an mb5 with the MLM rear grab rails that dont have turn signal mounts. Enter these guys. Mine are mounted on the rear "trunk" and they are pretty sleek and stock like almost. I mounted mine with some rubber washers to try and avoid breakage since they are hard plastic stems ya know.
Was this review helpful to you?
1 taco eaters like this review
These will probably break
April 23, 2013
taco eater :
JakeP from Riverside, CA United States
Yes, they're cheap and look pretty good if you want to replace some huge tomos or motorcycle/mb5 blinkers, but they do have some issues because of the low price: Lens screws will break the plastic easily The ground wire is soldered to a spring, the wire breaks off pretty quickly. Because they're not rubber mounted the vibrations from the road can cause you to blow bulbs which aren't available at local auto parts stores.
Was this review helpful to you?
0 taco eaters like this review
classier than stock
April 26, 2011
taco eater :
silverside61 from maine
I used these to replace signals on the front of a '99 targa. much smaller than stock, so they dont look big and limp and dookie like stock ones! quite bright, but there is no flex mount, so imagine any impact will break them, but at this price, who cares?!
Was this review helpful to you?
3 taco eaters like this review
You get what you pay 4!!!
September 14, 2010
taco eater :
Al Gloddy from South Weymouth, MA United States
They're more on the chincy side of the fence, but for the price you really can't go wrong. Plus, they make me feel stylish ,almost as if i fit into American society. I'm part of the mainstream god dam*nit. I drink my water from the mainstream just like all the other good sheep that get herded daily and do so without question. Hmmm.. Something's wrong... I think I sharted my boxer short's. yup, sure did.
mb5 rear signal replacement 
These will probably break 
classier than stock