taco eater :
rich from indianapolis, IN United States
not all the nuts threaded on very well kinda cheap also bearing cage was plastic dont know if your supose to put that in your bike or not i wouldnt and didnt had to reuse my old bearings ones that came with it were to large
Was this review helpful to you?
1 taco eaters like this review
throw the box out
December 30, 2011
taco eater :
Alex Sokolowski from denver , CO United States
because the box picture is confusing and totally different then the way mine went together.
i used this axle for the rare 17" italian acorn mag front wheel i found on here. it works great.
for my wheel i had to sand down the back of one of the plastic bearing holders. i also needed to grind down one if the lock nuts for the bearing nut, in order to get my speedo drive to fit properly.
good quality works great!
Was this review helpful to you?
2 taco eaters like this review
nice quality.
November 16, 2011
taco eater :
owen walker from gonnamakeitworkanywayville
good quality but not a drop in replacement for puch snowflake rear wheels. you would have to use your old bearings because the ones it comes with are too big. also the box they come in has an exploded view on it. like how it should go together, but the bearing cartridge/ cages are pictured backwards. FYI.