taco eater :
Dangertooth from Armstrong, BC Canada
Replaced my DIY hack-n-weld intake with this. It's SO much better.
The fit is tight, because it's perfect. You'll need to file down a nub on the cooling fin closest to the intake, and it should seat nice.
Was this review helpful to you?
0 taco eaters like this review
Grinding for av7
July 29, 2019
taco eater :
Nicholas from Idaho Falls, ID
Description says no grinding, but it wouldn't sit flat on my cylinder intake port. I did have to do some fun fin material removal to get it to sit well and seal up. Very nice piece otherwise. Just my experience, maybe my cylinder casing is off?
Was this review helpful to you?
0 taco eaters like this review
Wowee! We love holes!
November 16, 2018
taco eater :
Anonymous Person
Especially 15mm ones! Hey! I bet this dumb sucker would work on a hobbit too with just a little bit of adaptoid technology to the stock block/2pedalspacermajig