motobecane AV7 malossi SHA shorty intake
motobecane 15mm SHA dellorto intake
 



  $19.99

 :HERE NOW!!

qty:

 
 
malossi shorty intake for using on av7 (50v) and av88 engines to replace the stock gurtner with a dellorto sha carburator.

either the 15mm or 16mm dellorto will work great with this intake.

just imagine being able to change your jets! wow! revolutionary!

check the reviews below for more info, on some av7 cylinders you need to slightly file the fins or intake down to get a perfect seal, sorry!!

ID = 15mm
OD = 19mm

02 2066B

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 10 give your taco rating here

  0 taco eaters like this review
 
5 of 5 it works April 27, 2021
taco eater : burrito eater from SIOUX FALLS, SD United States  
works good with the dellerto 15. have to shim it down for this carb to fit on this but it works. little modifications to this to fit the express nc50. If you've never held a screw driver before, this isn't for you. I had to elongate the holes a bit, then had to dremel the bottom right side to clear the fender mount that is attached at the intake. worked awesome and have no leakage.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Good intake May 31, 2018
taco eater : Michael Malvo from Kirtland, OH United States  
Had to shave the intake for it to line up perfectly. It took 2 seconds with a file.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Super rad upgrade!! January 12, 2015
taco eater : Owin Carmody from Killingworth, CT United States  
I bought the whole sha carb party for my av7. Had to shave the top of the intake(took like 5 seconds with a file) bolted up grate! One downside is the plastic shim went bad on my carb and the intake casting was a bit off so I have to replace because of a insane air leak in the seal. Overall a sweet setup, just gotta be aware that it may have some defects. 👍

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Decent intake for NC50 March 9, 2014
taco eater : Max Maruszewski from Petaluma, CA United States  
One thing I did not notice when ordering this intake was that the actual place where the carb mounts is on an angle to the flat gasket surface, this means your carb will be angled down a little bit when mounted to a honda express, you can flip the intake and angle it up or down but it is not a straight shorty intake. Don't think this will matter but I have yet to try it.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Well needed - Hit the spot! February 10, 2014
taco eater : G Rashid from Dayton, OH  
Mine worked just well without shaving off the top. Maybe I got lucky, i dunno....  

Works great for my 15.15 SHA I used a 1mm shim and a clamp seal for a tight fit .

I'll get another for the other AV7.   - Buy a few, they're inexpensive and worth it.

Was this review helpful to you?

View All Customer Reviews