morini M1 & minarelli v1L reed block adapter for am6 bloxx

$54.99

:HERE NOW!!

qty:

NEW minarelli v1L + morini m1 big boy reed adapter! does this allow you to run an AM6 aka gila size reed block instead of the wimpy stock one? yes!

the bolt holes at the base of the adapter are slightly ovalized to fit both the minarelli v1L and morini m1 reed block bolt spacing!

You WILL NEED 2 low profile allen intake bolts, found HERE.

you will need to figure out an intake-to-carb situation that works with this. luckily we have tons of am6 and gila style intakes in the store.

there may be some complications with frame clearance depending on what frame your m1 / v1L is mounted to!!

c-c where it bolts to the case is 45mm
intake "square" where it bolts to the case = 31mm x 20mm

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 1 give your taco rating here

0 taco eaters like this review

On morini T4	May 24, 2026
taco eater : Xavier Bruno from Pignans, Var France

The part I'd been searching for for years for my Morini T4 70cc D46 cylinder! I bought it worried about the angle of the intake manifold, but it works perfectly. It's fantastic! I was finally able to install a carburetor bigger than 17.5mm. I installed a PWK 21 carburetor, and what a difference! 🔥🔥🔥 It's amazing! The low-end torque and acceleration are extraordinary compared to before with the small reed valve. Thank you so much!

Was this review helpful to you?

treatland