moped throttle cable for all mopeds
moped throttle cable
 



  $7.00

 :HERE NOW!!
qty:

 
 
dual nubbed throttle cable for all puch mopeds. Pre '77/8 use as is, or for later models cut off the top nub. This is, of course, also a puch 2 speed clutch/starter cable.

for maxi magnum newport cobra dart daimler swinger pinto freespirit murray korado

inevitably compatible with most every other moped. comes with a straight able adjuster.

cable end is M5 x 0.8mm threading

housing is about 39.5" long
cable is about 45" long

should be plenty long for your tallest stock bars. maybe? check it out

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 9 give your taco rating here

  2 taco eaters like this review
 
5 of 5 Cant be used for laparoscopic surgery August 15, 2017
taco eater : Treat Phreak from Hyannis, MA United States  
cannot be used for laparoscopic surgery as there is no way to secure a laser scalpel properly.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 Not for Pinto July 21, 2016
taco eater : Jacob Dodge from Middletown, CT United States  
I mean, its a cable and you can cut it and resolder an end piece, but it was far too long for my Pinto.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 sensuous throttle action August 2, 2015
taco eater : E from Torrington, New England  
(Sept 2014) Needed a throttle cable with a bigger knarp on the grip end... I've got the early-style switches and grips on my 77 Puch

Knarp was the right size for my throttle grip, but I had too much slack with the elbow on my 12mm bing... had to raise the elbow out of the carb's cap, and dial-out the cable adjuster at least 3/4ths of the way.

Might want to scrape off the extra metal bits on the other end of the cable that hooks into the carb slide.  There's some extra residue around the seam of the molding for the knarp, and I was afraid of it falling off and getting sucked into my intake... maybe I'm just OCD?

[Aug 02 2015 Edit:] so after using it for a few months, the cable started to fray a little bit where the throttle sleeve guides it between the grip and the cable sheath.  I figure it just fatigued due to the channel that it slides in.  Might want to consider some kind of grease or lube.

Was this review helpful to you?

  4 taco eaters like this review
 
5 of 5 So awesome for hobbit. November 20, 2012
taco eater : JakeP from Riverside, CA United States  
Perfect if you're running a mikuni on a hobbit. VM18 or VM20. You can even use it on your stock carb if you cut the small end off and shorten the housing some.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Free is good January 25, 2012
taco eater : Nicholas Badman from Dover, DE United States  
My stock cable was falling apart and this cable works perfectly, it came free with a dellorto carb party pack. Sick!

Was this review helpful to you?

View All Customer Reviews