minarelli V1 L brn 40.3mm 50cc cylinder kit - 5 port
minarelli V1 L brn 40.3mm 50cc cylinder kit - 5 port
 



  $160.00

 :HERE NOW!!

qty:

 
 
BRN 40.3mm 50cc cast iron kit for minarelli V1 L case inducted motors.

***these kits NEED TO BE CLEANED before running! there are still some cast iron shavings/gunk in the transfer ports. the rings will also need to be gapped as there is almost no gap at all as is! but this was all stuff that you should do anyway when prepping a kit for install yup. ***

dual ring piston! 5 ports!

includes cylinder, piston, rings, wrist pin and clips...no gaskets sorrrry!

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Deck that bitch and clean up the ports. do 55 February 23, 2020
taco eater : simon thokaar from ofallon, MO United States  
Its really for a v1 stroke, so either run a v1 crank or sand off a few mm.  I ran it with a vm18 and an estoril pipe.  Brace your swingarm too, broke mine a few times with all them torques.

Was this review helpful to you?