metal petcock long lever down flow - 12mm thread
metal petcock long lever down flow - 12mm thread
 
  $19.94

 :HERE NOW!!

Free Shipping
qty:

 
 
metal petcock for many mopeds! if you like the long lever reach this might be the cock for you! fuel flows straight down - for 5mm fuel line 12mm x 1mm female thread coupler nut

ps.. these are original NOS petcocks so they may be a little sticky at first but give them a gentle but firm twist and they'll be good to go!

reportedly works perfect on vespa grande!!

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 5 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Excellent Replacement Petcock for Grande May 17, 2023
taco eater : Luke N. from Shoreline, WA United States  
Used this to replace the original leaky petcock on my Grande, works like a charm, no leaks with the aforementioned o-rings installed.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 Great petcock May 28, 2017
taco eater : Ninja from New York, NY United States  
This is the one I use on all my Grandes that need new Petcocks. The handle is long and metal not plastic like most. The petcock fuel filter will fit if you jam it in. I will not remove that filter, it was built in for a reason. It's a tight fit but it will fit in the Grande frame.

WARNING - There are 2 small plastic white/clear o-rings that goes around the inline fuel filter. Those o-rings are necessary for the petcock to seal to a Grande spicket. Without those 2 pieces the Petcock will leak. Keep the o-rings in place and it's an amazing petcock

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Happy with my petcock! October 8, 2013
taco eater : Rodrigo Molina from Somerville, MA United States  
Good quality, works well, as advertised and fits my Vespa grande.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Fits Grande October 29, 2012
taco eater : Anonymous Person from Rochester, MI United States  
Yes it fits, but you must re-use your old filter. DO NOT revmove the filter from the petcock!  The filter does two things. One is it filters gas going to the carb of course. The second is it prevents the petcock from clogging!  
Simply unscrew the nut from the old petcock. Use an old toothbrush and brush the bottom of the filter where it meets the cock. Twist the filter off with your fingers.  Next, twist off the new filter. You must then cut a small section off the clear stiff hose on the cock. Look at the old and measure from that. Then screw on the old filter to the new cock, finger tight. You're done!

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Vespa Grande Petcock September 6, 2012
taco eater : Rob from Portland, OR United States  
This is the one you want for your Grande! I pity the fool that buys the wrong petcock... you want the fuel to flow straight out.. not up or any other weird angle. The filter is about an inch too long... no biggie, just remove it and buy an inline filter.

Was this review helpful to you?