taco eater :
A Bandit from Louisville, KY United States
Gasoline and heat will warp this cage after a while. I had a horrible air leak after a while and found that this was the source.
Was this review helpful to you?
2 taco eaters like this review
Bolt holes don't match up.
March 3, 2012
taco eater :
Frank Horrigan from cape coral, FL United States
I wanted to rip rip but the bolt pattern doesn't match up. Made sure the reeds weren't in upside down. the top of the rev plate get's stuck on the cylinder so I drilled the holes larger to have them sit lower. this was for a tomos a35.
Disaster avoided.
Was this review helpful to you?
0 taco eaters like this review
Flappy.
January 20, 2011
taco eater :
Rocky from Providence
I like these reeds quite a bit. It's a good choice for replacing the miniature reeds that come stock on a 103. Put this and an SHA on your stock bike and go.
Was this review helpful to you?
1 taco eaters like this review
Carbon Yeahhh
May 18, 2010
taco eater :
michael ricereto from baltimore, MD United States
I have never installed any other reed block before but the quality of this piece is impressive and my bike is screaming so it must be good. It's one big reed, so if you know a lot about this sort of thing, keep that in mind. There was no way I was going to A/B compare the stock reeds when I kitted my little Lion so I can't say what this will do for you but I'm happy thus far for sure.
warps 
Flappy. 
Carbon Yeahhh