taco eater :
Scott Cerveny from Owosso, MI United States
Yes. eats cables. run a 90 degree tube off the straight cap. CUT a slot into the bottom of the frame. sink a piece of U channel in there. weld. leave one end open to run cable thru the frame. drill a hole in the frame somewhere hidden under the gas tank. run cable thru it. bada bing bada boom.
Was this review helpful to you?
0 taco eaters like this review
steer clear
May 28, 2011
taco eater :
Ryan Nash from Columbia, MO United States
this WILL eat your throttle cable for breakfast, lunch and dinner on a hobbit... you will be replacing your throttle cable every two weeks. avoid at all costs and make your own intake so you can use the right top cap.
Was this review helpful to you?
1 taco eaters like this review
good for a while
July 27, 2010
taco eater :
rob moen from portland, OR United States
These are great for the hobbit setup. However, I advise you to be careful at max throttle. I've torn through the bottom component and am on my third set. I've also gone through about 3-4 cables in the last few months. I would love for someone to make a stronger version of this.. . Perhaps hmm idk.. .metal vs plastic ?
Was this review helpful to you?
1 taco eaters like this review
so so
April 30, 2010
taco eater :
Adam Babel from Eau Claire, WI United States
this is ok, but so far it has been eating my throttle cables. ive gone through two so far. i think using a throttle cable guide might help that situation. a metal version would be muck better too i think.