malossi 19mm lil intake for PHBG carburetors
malossi 19mm lil intake for PHBG carburetors - 02 0472
 
  $19.99

 :HERE NOW!!

qty:

 
 
malossi 19mm clamp style PHBG intake

24mm clamp mount OD so this will work with any clamp style PHBG with a 1mm shim

this intake has an overall length of about 56mm and sits at about a 37 degree angle

goes from circle to circle measuring 19mm on the intake side and 22mm on the cylinder side!

center to center of bolt holes is 42mm, but the holes are rectangular so there's a lil room to move it around.

warning! you have to use studs because the intake shoots right over one of the bolt holes and will not allow you to put a bolt in there! it's a little tricky but will work perfectly with the right length stud

02 0472

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Awesome!! November 23, 2023
taco eater : 76rigid from United States  
I thought these were discontinued back in the 80's.  Mounted my original on my ZA50 Metrakit in 1999 till today.  Thanks for the spare!!!!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 5 tacos May 8, 2018
taco eater : B Doorn from Long valley, NJ United States  
Insanely good intake for a cheap price- mounted this on an a55

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Nice October 26, 2017
taco eater : Veikka Ankkuri from Jalasjärvi, Jalasjärvi Finland  
Very good quality and fits almost every piston port engine with minimal work needed. I have this in 74cc monza with 21mm dellorto and it works nice!

Was this review helpful to you?