NOS magura GREY throttle assembly - RIGHT - v1
magura GREY throttle assembly - RIGHT - v1

alternate reality price $89.99


this is an ORIGINAL german quality NOS OEM throttle assembly found on many bikes like early puch maxi, sachs, kreidler, 70's tomos and lots of other mopeds too. check it out, see if its for you! NOT a reproduction or china copy!!!

you know how these always get loose when the clamp gets tightened down one too many times and you shove some beer can shims in there? yeah, no more doing that! get a new old stock one here!

works with this brake pin!

*these may come with a brake button that probably doesnt work or might have damage or might not even come with one. its old, real, and sitting around for many years. if it works its a bonus!! That said most will prob work, but if it doesn't we're not sending you a free one. also, the grey coating will have some pitting and scratches, give em a break, they are PROBABLY older than you!!!*

**ALSO these are dirty and have been kicking around some warehouses for many years, as you can see in the photos, there are small nicks and scratches on em!**

comes with clamp bolt, lever bolt with special nylon nut and even brake lever return spring!!!

normal 7/8" handlebar size

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
5 of 5 Fits like it was meant to be, because it was! June 28, 2020
taco eater : Mike from Denver, CO United States  
Exact match for my swinger 2’s old throttle assembly. Also got the magura throttle tube and a nee cable, all worked to get it back to WOT-mode. The trick to getting the throttle tube back on the assembly was to connect the two at the very edge of the handlebar. Slide assembly to edge of handlebar, put the throttle cable in the tube, wriggle the tube into the assembly and twist the tube until it locks into place. Don’t over tighten the clamp on the assembly, it may snap, which would be a zero taco kinda day.

Was this review helpful to you?