|
|
|
|
|
Made my MP swingarm oh so factory tight |
July 15, 2020 |
taco eater :
cheetahchrome from penryn, CA United States
|
|
Be sure to clean the old bushings out with a drift or square blade screw driver. Sand off any old grease or rust from around the head of the swing arm bolt. This is because you will want to use the bolt as a tool to keep the bushing from collapsing as it is driven into the frame hole. slide the new bushing all the way on the bolt till it rests flush against the head of the bolt. You will want to oil or grease both the frame hole and the bushing then slowly tap tap tap till the bushing is all the way home.
Was this review helpful to you?
|
|
|
|
|
|