honda hobbit mikuni vm20 intake for hackerzzzzz
honda hobbit mikuni vm20 intake for hackerzzzzz
 



  $66.99

 :HERE NOW!!
qty:

 
 
NEW cnc aluminum hobbit intake for use with the awesome mikuni vm20 carburetor!!

***NOTE THIS IS FOR HACKERS N TUNERS!!! MORE SO HACKERS CUZ THE CARB TOP CAP WILL NOT CLEAR ON A STOCK HOBBIT. SEE PIC, WE TRIED AND FAILED!!!***

this intake is more for hack n weld projects/frankenstein builds where ya got extra clearance!!

get a gasket here

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  1 taco eaters like this review
 
4 of 5 There's potential here... July 26, 2021
taco eater : Mike Boyd from Los Angeles, CA United States  
Unscrew the top cap of the VM20, then remove/unscrew the cable adjuster in the cap. Measure the threaded hole for the cable adjuster- both the diameter (i think it's m6) and depth. Next buy a bendy-elbow cable adjuster (link below)
Here's the tricky part- carefully drill out the threaded hole for the adjuster on the carb top just enough so it's no longer threaded. Put the bendy adjuster in and use a punch to carefully flare out the bottom end. You now have a shorter 90 degree adjuster that is not threaded into the cap but also won'y pull out, which allows you to unscrew the top easily for needle adjustment while also saving space for the cable run under the hobbit frame.

https://www.treatland.tv/bendy-p/throttle-cable-90-cable-guide.htm

Was this review helpful to you?