honda MB5 malossi PHBG carburetor kit
honda MB5 malossi PHBG carburetor kit
 
  $150.00


qty:



here's what ya get in this PARTYYY!:
 
 
honda mb5 malossi carburetor kit - including dellorto 21mm phbg AS carburetor + 21mm intake with oil injection inlet + two intake gaskets.

PHBG three jet carburetor comes with pull choke

fits a wide range of honda models - MB5, MB50, MBX,MTX, so on and so forth.

do your research! lots of info HERE if ya need it.

This is not meant to fit together with the stock airbox and the carb will sit at an angle on MB5. PHBG are designed to run at up to 45 degree angles so the small angle this fits at is totally fine.

main jet = 92
idle jet = 50
starter jet = 60
slide = 40
needle = W7
atomizer = 262 AU

16 10703

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 5 give your taco rating here

  1 taco eaters like this review
 
5 of 5 Perfect upgrade September 15, 2018
taco eater : Anonymous Person from DECATUR, GA United States  
Fantastic upgrade. I highly recommend it. Chances are, you'll need to enlarge some of the intake mounting holes to get a nice fit against the stock MB5 cylinder.
Stock throttle cable works perfectly. This does not mount up to the stock airbox. I recommend a UNI pod filter. The 1 1/4" ID 3" LENGTH, Angled 2-stage UNI filter bolts on perfectly.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Big difference compared to a 19mm carby January 7, 2016
taco eater : Bennett Lauderdale from Gillette, NJ United States  
Had a 19mm carby on my mb5 with a 70cc kit and it was a huge difference just had to get it tuned up right now my mb5 rings like a bell

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 very nice February 26, 2015
taco eater : Stefan Thies from Calgary, AB Canada  
put it on and beginning some trouble with getting to run. turned the idle screw very far in. Then adjust mix and get the idle back to normal, 1200 rpm and runs perfect very high rpm now possible

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Nice Carb and Intake March 7, 2014
taco eater : H D Davis from Littleton, CO United States  
Put this on my stock MB5 without issue. Only had to adjust the idle speed screw. Yeah, choke is a little inconvienent, but not bad because warms up quick.

Improved starting, idle, and performance.

Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 Clearance Issues September 6, 2013
taco eater : leviathan from Manchester, MI United States  
So this is an AMAZING carb.
the one concern is clearance, you really have to have little hamster hands in order to be able to reach into the bike and pull the choke.
Definitely get some sort of lever/cable to adjust for this.

Was this review helpful to you?