honda MB5 airsal 45mm 70cc cylinder kit
honda MB5 airsal 70cc kit
 
  $142.99

 :HERE NOW!!

qty:

 
 
honda mb5 airsal 70cc nikasil lined aluminum cylinder kit.

comes with - cylinder, piston, ring, wrist pin, clips + head, base, intake and exhaust gaskets

fits a wide range of honda models - MB5, MB50, MBX,MTX, so on and so forth. do your research!

lots of info HERE if ya need it.

this will dust the malossi!

02040845

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 7 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Also using mikuni vm20 #273 jetting roundabouts?? September 11, 2023
taco eater : Scott H from Richmond, IN United States  
To Hayden from grand rapids.. where did u end up on your jetting for the mikuni? Thanks!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Airsal review. Best Kit for the money May 26, 2019
taco eater : Richard Pellegrino from Albuquerque, NM United States  
Please see my review on the Malossi as it out lines the differences between this system and the Malossi. I run both set ups. In comparing this to stock, the stock mb5 when ports are polished and running the Dutch pipe with hit a higher top speed. However my airsal kit deliver balls out snort to climb long uphills and I weight 225 lbs at speeds of 65 mph. I love this kit for the price it it is hard to beat. Use the 70 cc hi comp head and a techno pipe along with the HPI ignition and hold on for dear life. The proma pipe is not as good on the high top end. Super high quality set up and so worth the little change Benin and Dana are asking for this hot kit. Really works great and runs hard. Really great kit!!

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 A little disappointed May 29, 2018
taco eater : Conan Segar from North Myrtle Beach, SC United States  
So I have now seized 2 of these at low temperatures, between 287 and 320 with correct jetting, correct break in procedures, needle set to proper position, proper mixing and a clean tank. The 1st kit seized in 6 miles of light riding, the newest kit made it through a whole rally weekend of blaaaasting in STL, I ride it to work this morning which is only 2 miles away and I walked a half mile in after the sieze. There was 82 miles put on this kit.  I guess the moped God's are telling me to pay up for the more expensive kit.

Was this review helpful to you?

  2 taco eaters like this review
 
4 of 5 Nice cylinder April 1, 2014
taco eater : Hayden Butcher from Grand Rapids, MI United States  
I installed this kit and a 20mm mikuni and love the new low end  grunt that my bike has. I have done about 2500 miles on it now with no problems.
 Just get your jetting right and your off.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Great upgrade!! March 7, 2014
taco eater : H D Davis from Littleton, CO United States  
Easy to install. I matched this with Dellorto carb PHBG 22 and Homoet pipe. It's like a new bike.

Was this review helpful to you?

View All Customer Reviews