taco eater :
michael kuriger from Santa Clarita, CA United States
Fits on my 70cc Athena kit It's a tad wide, but does on my 75cc Airsal kit with a little grinding inside the piston.
Was this review helpful to you?
0 taco eaters like this review
Spacing washers no longer needed!
June 17, 2018
taco eater :
Robert Smiley from Fountain Valley, CA United States
I was using 3 stainless thin 12mm washers from McMaster-Carr on each side of the stock bearing to keep it centered on several "kits". What a pain getting it all aligned! With this I didn't need them anymore. 5 tacos!
Was this review helpful to you?
0 taco eaters like this review
Fits Malossi H2O 70cc
January 17, 2013
taco eater :
Aaron Fogg from Memphis, TN United States
Perfecto. Just enough slack so it won't seize on the piston sides, yet wide enough so it won't walk out to one side and explode.
Was this review helpful to you?
0 taco eaters like this review
DOH Should have measured
April 30, 2012
taco eater :
Anonymous Person
too wide for my large port puch Metra80 kit, the pistons measure 16.5mm on the inside.
Was this review helpful to you?
0 taco eaters like this review
Too Wide
June 10, 2011
taco eater :
Cooper Hennick from Grafton, WI United States
This is too wide for the puch gila... or at least mine. The gap in the piston on mine is 16mm wide.