puch e50 straight cut gear complete set - KICKSTART / PULLSTART
puch e50 straight cut gear complete set -KICKSTART
 



  $420.00

 :*sorry none today*

qty:

 
 
brand new extremely breathtakingly beautiful set of straight cut gears for kickstart / pullstart e50 !!! this pack comes with a lightened main gear, lightened clutch bell and clutch bell bushing

you will not be able to use your starter plate assembly, so its time to lighten up and go with pullstart or if youre lucky enough to have a kickstart youre good to go right off the bat!

the 94T main gear itself weighs 1.89 lbs

the 18T clutch bell weighs 12.6 oz

inner diameter is for a normal puch clutch but does not have the extended area for the starter plate mechanism

main gear has circlips on it already too

seriously high quality. the clutch bushing slides in so nice....kinda like modern art, its a shame they have to be hidden inside your engine!!!!

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 For the ripper who has everything. May 22, 2018
taco eater : Anonymous Person from minneapolis, MN United States  
want to eek that last 2% out of your fiddy? Already have a bike that tears the rear sprocket smooth? Do you have $1000 into your engine alone? This is the last upgrade. You have reached the end of the road with this guy. Let’s throw one on the dyno and see what happens.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Nice, but.... May 22, 2018
taco eater : squirrel from amish country  
...make sure your kickstart e50 is a FOUR BEARING, not a THREE BEARING. There is a difference. I bought this for a 3 bearing kickstart e50 thinking I would just not run a bearing on the small end of the main gear. However, the main gear on a three bearing has a slightly longer end that sits in the channel of the case. You could maybe try to run it, but you will probably end up damaging something since the main gear has room to walk in the case. This was my fault as I assumed it would fit, but I am writing this review in case anyone else has a "euro kickstart" e50 like I did, or korado 3 bearings. Magnum X uses 4 bearing so this should work fine, same with pedal start e fiddies.  

As far as quality goes, these look amazing. My friend has the same set in a gila e50 and you can definitely hear them whine, but it isn't unbearable. The exhaust is still much louder.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Holy moly October 24, 2017
taco eater : Anonymous Person from Green Bay, WI United States  
I just creamed my pants


Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Wow October 18, 2017
taco eater : Countryob from Princeton , MA United States  
Wow

Was this review helpful to you?