dellorto SHA type II carburetor clamp seal
dellorto SHA type II carburetor clamp seal
 
  $3.99

 :HERE NOW!!
qty:

 
 
this little seal goes in the clamp area of the carburetor then the type II plastic shim goes in after that.

newly discovered, it was previously unknown that this thing even existed!

these are not sold separately by dellorto anymore so we rarely get them. the easy way to get them is in this complete gasket set!

for the bigger size SHA carburetors 14.12, 15.15, 16.16

also, original for some tomos models, part number 227324

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Works with bings as well January 26, 2014
taco eater : David Mooney from Portland, OR United States  
So I had a trouble with a bing not sealing properly on my puch and I tossed one of these in the carb and now no more airleaks.  Its not a perfect fit but it seems to have get the job done.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 can make it work December 20, 2013
taco eater : Chris Lewis from Dallas, TX United States  
I got one of these to replace the original shim in my 16.16. It is not as long as the original, which I guess is why the description mentions that other seal. You can make it work alone by trimming down the lip on this shim and pushing it farther into the carb. It took me a couple of weeks to figure this out and cut off the lip to close up the massive air leak I had in the intake beforehand. Now I can idle!

Was this review helpful to you?