dellorto SHA 15.15 carburetor with lever choke - 1.5 shim for tomos
dellorto SHA 15.15 carburetor
 
  $67.00

 :HERE NOW!!
qty:

 
 
dellorto SHA 15.15 carburetor with lever choke - 1.5 shim for tomos

thats right same great SHA taste but just for tomos mopeds only!

and possibly other bikes that take this shim.. 18mm ID

upgrade that tomos! throw a kit on that thang! oh, and a 15.15 sha carb too. comes with a 68 dellorto main jet!

if you plan to use this carb with an MLM sha intake you MUST get this shim too - 1.00 shim found here!!!! so you can grab this carb and the shim and be all good. if you don't grab the shim you will not be all good. easy.

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 6 give your taco rating here

  1 taco eaters like this review
 
5 of 5 Perfecto on Derbi PP December 17, 2018
taco eater : Anonymous Person from NH United States  
this is the shim you need for a piston port derbi stock intake, or ya know the tomos guy

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Amazing little carburator! September 21, 2017
taco eater : Rapidrob from Edgewood, NM United States  
I replaced my original carb on my '78 Honda NC50 Express with this carb and installed a #58 jet for my high altitude.(7,000 feet ASL)
The carb works perfectly and 99% of the time no choke is needed and it starts with the first wind up!
Very smooth idle with no hint of stalling.
The air cleaner is very compact and does not stick out like other do. Use the Treatland carb adapter.

Was this review helpful to you?

  3 taco eaters like this review
 
5 of 5 the real deal November 1, 2016
taco eater : tim ostrom from savannah, GA United States  
i've got a few of these on a few of my bikes. i love them. i used to like bings more. nah. i used to get big ass carbs and try to go super fast. whatever. the '15 SHA is all you need. i've gotten well over 50 mph on one (airsal tomos) and they work great on stock setups too. the inlet filter is great for your rusty ST tank, and the "mouth" makes custom air filters a breeze. what are there, like 5 screws on the whole thing? 1 jet. suuuuper simple. almost noob proof. get one, upjet till it 4ts, down jet like 1 or 2, then BLAST.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 make sure your id / od fit December 22, 2014
taco eater : Anonymous Person from Orlando, FL United States  
This + MLM 15mm a3 intake + intake gasket + bag of jets was a needed upgrade to my 1984 tomos silver bullet a3 gm.

Didn't fit with plastic shim provided, to loose without it, had to sand to make fit.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 patrick from pensacola December 30, 2012
taco eater : Patrick Hutchinson from Pensacola, FL United States  
running this on a a3 with an alukit and a techno circuit and hitting around 40....works great and does exactly what i hoped it would

Was this review helpful to you?

View All Customer Reviews