taco eater :
Chase SATX MONO NOLA from San Antonio, TX United States
This bar comes out of the package "general use" and must be modified, but it can be done using a simple jigsaw with a metal blade. I removed one of the circlips and then put the bar through the pedal shaft hole, and then scored the metal where the circlip needed to be on the other side. Then I put the bar in a vise and cut around it to make another circlip groove which worked fantastically! No need to use any washers here! Then, you can cut the bar to match exactly where you want the pegs to slip onto on either side for a perfect fit. I use hairspray to slip on the peg rubbers.
Was this review helpful to you?
0 taco eaters like this review
sturdy footpeg conversion
September 5, 2017
taco eater :
Paul S from Troy, NC United States
installed on my pinto, little play side-to-side. nothing a washer or o-ring can't fix.
Was this review helpful to you?
0 taco eaters like this review
Shafts
June 14, 2015
taco eater :
Rourke Kendrick from Fairfield, CT United States
This shaft is huge! And beware, this is most likely heavier than your original pedals and cranks. A little to wide of a shaft for my liking, but you can always cut it down. OUCH!
Was this review helpful to you?
1 taco eaters like this review
Nice, strong and cheap
January 21, 2013
taco eater :
derek stahl from Denver, CO United States
Fit maxi and pinto frames perfect, a bit long and definetly too long for kickstart e50 but easily cut down to whatever size you'd like. I have mine on a maxi-N w/kickstart e50 and had to cut 1" off.
Was this review helpful to you?
0 taco eaters like this review
Work well
August 28, 2012
taco eater :
Anonymous Person from Oakland, CA United States
Hope the fact that they are solid won't be an issue if I lean over too far...
Excellent bar after modifications for 77 Ciao 
sturdy footpeg conversion