taco eater :
Juls_Italy from Jacksonville, FL United States
Everything said in the other reviews is true—once you remove the holding screw, it falls apart and is very hard to reassemble.
HOW TO INSTALL IT: Use pliers to slightly bend two sides of the gold button disk and mark them with a marker. While pressing the button down, insert the two support arms and make sure you can see the marked parts through the small window. Keep the button pressed while mounting it to the handlebar.
Took about 30 minutes of frustration, but once installed it looks great and works perfectly.
Wired to the white wire on a Kinetic TFR.
Was this review helpful to you?
0 taco eaters like this review
Clamp sucks.
January 23, 2025
taco eater :
Kenneth Hill from Arnold, MD United States
Absolutely will not tighten securely around a standard bar.
Was this review helpful to you?
0 taco eaters like this review
thing exploded on unpackaging
April 24, 2013
taco eater :
nicholas thomas from Spokane, WA United States
pieces went everywhere. pretty sure i lost something, since when i finally got it hooked up and fired up the ped, it would not "kill" it, but only electrocuted me. I ripped it off and now i just use the old duck tape the bare hanging wire method. spend some dough on a nicer kill switch.
Was this review helpful to you?
1 taco eaters like this review
awesome...eventually
August 2, 2011
taco eater :
Anonymous Person
once you finally get this mounted (once you take the screw out the first time the whole thing explodes) while holding it together, it is just stunning, and looks incredible. buy it! i bought this one as a horn switch, and the red one as a kill switch. good times!
Looks Great Once Installed, Tricky Assembly 
Clamp sucks. 
awesome...eventually