taco eater :
Raven Tiffany from Boulder, CO United States
Fits square 12mm bing, very nice.
Was this review helpful to you?
0 taco eaters like this review
Nice when you need it
September 20, 2015
taco eater :
Jim from Lincoln, NE
Did you use a socket wrench to tighten your clamp bolt? You broke it, didn't you... This will replace it. Use a screwdriver next time.
Was this review helpful to you?
0 taco eaters like this review
Worth the money.
April 8, 2014
taco eater :
Matt Ketner from Superior, CO United States
I bought a 1978 Puch Maxi that had a leaky 14mm Bing carb, due to a worn out clamp bolt, and replacing this helped solve the problem. Before I installed the carb back on my Maxi, I put some jb-weld where the clamp bolt squishes the metal and now its 100% AIR-TIGHT!!
Worth the money!
Was this review helpful to you?
0 taco eaters like this review
Like a charm.
May 20, 2013
taco eater :
Adam from Gulfport, MS United States
Fit right on my 14mm Bing carb, and sealed up tight.
They even threw in some treats stickers because they're awesome ;)
Was this review helpful to you?
0 taco eaters like this review
Good but no 10mm
July 16, 2012
taco eater :
bababooey from pa
About the same length as the original and seems to be of slightly higher quality. But, there is no fitting a 10mm on this bad boy.
I like the convenience of being able to use a 10mm and not worrying about having a shitty flathead that will slip out of the notch.
Square bing 
Good but no 10mm