taco eater :
Drake Abrahamsson from San Clemente, CA United States
it took me breaking 2 of these to get it onto my carb! not sure if that was just me being a noob or if it was the gasket! one thing is for sure is they're not all the same. after comparing my last 2 (i bought 4 having a feeling this would happen) they were different so I chose the slightly larger one and was very careful and i used the float bowl to press it down once it was 90% there and it didn't break! but yeesh the first 2 were frustrating. 3 stars for 3 gaskets to serve one purpose
Was this review helpful to you?
0 taco eaters like this review
Worked well enough
February 14, 2018
taco eater :
Andrew Johnson from Madison, IN United States
Considering the age of the bike this seems lucky enough to find but it worked pretty well for me.
Was this review helpful to you?
0 taco eaters like this review
Too Big
July 14, 2017
taco eater :
Anonymous Person from Colebrook, CT United States
Luckily I bought two because the first one bound up and broke. The second was still too big but it didnt break and I was able to press it in when I tightened the bowl.
Was this review helpful to you?
0 taco eaters like this review
ripped
December 22, 2016
taco eater :
John Zona from merrimack, NH United States
was too big and did not sit snug. bunched up on itself and tore.
Was this review helpful to you?
0 taco eaters like this review
Gaskets are to big and not true to the brim
September 22, 2016
taco eater :
j B from Hbg, PA United States
I bought two gaskets and both were over sized and not a true circle. The were also not the same consistent width. Since both gaskets did not seat well even by being patient I had them both kink on me! In the end they both leaked out I am dead in the water. I may go with a rubber one to see uf I can get a good seal.