taco eater :
Magic Johnson from St. Louis, MO United States
One thing to look at is the weld on the connection of the two tubes I had a hairline crack that was the source of air leeks and was hard to detect since it was so thin. Also i decked the intake mounting surface to get rid of high low spots for a better seal other than that a good design but has some kinks. But hey that's mopeds
Was this review helpful to you?
1 taco eaters like this review
Yo!
March 25, 2012
taco eater :
MoorePeds from Weedier 562, CA United States
Make a Backwards Facing one yo!
Was this review helpful to you?
0 taco eaters like this review
Great!!!
September 18, 2011
taco eater :
ariyuki nakajima from yokohama, kanagawa Japan
Combined with a 21mm OKO. Both power and is the best response.
Was this review helpful to you?
0 taco eaters like this review
Another great intake by the Weak-Ends
June 23, 2011
taco eater :
Matt Doan from Los Angeles, CA United States
This intake is great for people who want the power that is offered by a 4 petal reed setup but don't have the skills or the resources to fabricate an intake. The powder coating is great. Pedals clear 100%. I hacked of the flange so that it can accommodate a Spigot mount PHBG. The tubing isn't round but it still seals up awesome. no big deal. My only gripes with it is you that you'll need a straight flow petcock for this one or you can reposition the petcock like the description says. You also wont be able to use all of the fuel in your fuel tank since the carb is a bit too high.