Tomahawk Xtreme kit for doppler mbk & peugeot clutch pulleys
Tomahawk Xtreme kit for doppler mbk & peugeot clutch pulleys
 



  $75.00

 :HERE NOW!!
qty:

 
 
***these now come with the proper m8 castle nuts and cotter pins!!***

Finally a heavy duty kit to replace the Doppler clutch pulley weak stock 6mm shoe posts that bend or break under big power.

Hereís the final version with laser cut STAINLESS steel triangle brace (installed on the pulley) + machined steel 8mm posts heat treated + m8 serrated flange nuts.

The thicker base of each post allows the shoes to fit deeper inside the clutch bell for more grabbing surfaces but with enough clearance so the posts donít rub against the bell. Thereís also a special flat section to hold the post with a wrench when tightening the post nut.

To upgrade your Doppler clutch pulley remove the stock 6mm pins, drill 5/16 holes, tighten the heavy duty 8mm shoe posts with the included m8 castle nuts. Install the clutch shoes and the triangle brace plate with the stock Doppler circlips.

ALSO the posts use 9mm circlips if yours are missing. grab some here!

Et voila, youíre ready to rip!

taco rating 5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
It comes with Free Nuts !!!! August 8, 2016
taco eater : Aaron Fogg from Memphis, TN United States  
Buy this shit

Was this review helpful to you?

  0 taco eaters like this review
 
Get this! August 5, 2016
taco eater : brian schulz from Evanston, IL United States  
This kit is awesome!  I have this on all my clutch pulleys.  Ensure your $250.00 Clutch Pulley doesn't go to the graveyard.  Can you buy just a pulley.....NO... so if your bent pins mess up your pulley there goes $250.00..  Also with the crown nuts you will never have to worry about the stock pins backing out either.

Was this review helpful to you?

  0 taco eaters like this review
 
the bomb February 28, 2014
taco eater : Alfred Yap from Artesia, CA United States  
The best upgrade money can buy. It could make you fly, without worrying.

Was this review helpful to you?

  1 taco eaters like this review
 
Bulletproof February 15, 2012
taco eater : Christophe Naulet from Los Angeles, CA United States  
The steel plate is not stainless. It shouldn't rust inside the bell but make sure to keep a thin coat of grease. You can also powder coat it, there's room for the circlips. Just cover the 3 small holes or gently sand off the paint.

Was this review helpful to you?