Return to wiseco needle bearing - 12 x 15 x 16.3
 :
page of 1


  0 taco eaters like this review
 
5 of 5 Works great on Peugeot Bidalot kit Thursday, December 24, 2020
taco eater : Mitchell Hoover from San Jose, CA United States  
Im using this beef boy for my 40mm Bidalot kit on my pug, it fit perfect. It looks amazing, haven't run the engine though. I imagine it would work on alot of kits so measure and go for it.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Work on Giraldoni and Athena if you sand a little Wednesday, June 6, 2018
taco eater : Puch lover from MOUNT-ROYAL, QC Canada  
It fit the Giraldoni 74 cc and Athena 70 cc red valve pistons if you sand the bearing eadge a little bit on a thin sand paper on a flat surface, instead to work into the piston were you have not a good control.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Fits Puch AJH Monday, May 4, 2015
taco eater : Maci Dub from Dubvue, WA United States  
Got about 17mm between the bosses in the DMP AJH piston and this bearing works perfectly without worry of it walking out too far.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Very Nice Bearing Tuesday, March 24, 2015
taco eater : Sean Lynch from Tucson, AZ United States  
It'll fit a TCCD 70 piston with a bit of cleanup in the piston.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 great bearing Saturday, October 26, 2013
taco eater : sean t from san jose, CA United States  
I don't need to tell you that wiseco=superior quality. This particular needle bearing works perfect with the treats reed kit.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 For my Gila Thursday, August 22, 2013
taco eater : EDWARD MANHART from OMAHA, NE United States  
Did not fit, but if you are building a Gila, chances are you have the tools to make it work. Had to grind the piston a tiny bit, then it slid right in, just how I like it.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 The best ever Friday, August 16, 2013
taco eater : Graham Motzing from GREENSBORO, NC United States  
pretty much the best needle bearing you can put in your high rpm ripper bikes. Wiseco is top notch

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 It MIGHT fit your Puch Gila Saturday, June 1, 2013
taco eater : Cooper Hennick  
Doesn't fit mine. Does fit someone else's. So measure yours. :D

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 High quality, fits treats reed/ajh pistons Thursday, November 29, 2012
taco eater : William Caldwell from San francisco, CA United States  
title says it all!

Was this review helpful to you?