Return to puch moped M6 cylinder engine heat treated studs n nuts X 4
 :
page of 2
Click to see more items


  0 taco eaters like this review
 
1 of 5 No good. Thursday, May 30, 2013
taco eater : Funkenet from MPLS, MN  
Stripped very easily

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Umad? Tuesday, February 5, 2013
taco eater : Archie from Ypsilanti, MI United States  
Honestly? Yes. I snapped one trying to torque it down.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Great! No Problems so Far. Sunday, January 6, 2013
taco eater : Gabriel Lagunas from Chicago, IL United States  
I have Had them for a while i don't see how people complain about them not being able to torque down. I got mine to torque down up to 8ft lbs. Had no problem.

Was this review helpful to you?

  1 taco eaters like this review
 
1 of 5 Piss poor Sunday, June 3, 2012
taco eater : Cameron from Boston, MA United States  
Stripped way before required torque for a stock head.  Worthless.  These might as well be made of cheese.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Don't bother Tuesday, May 8, 2012
taco eater : owen walker from san diego, CA United States  
Worthless. Lasted one installation.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 no issues Thursday, November 10, 2011
taco eater : Eric Cox from Columbia, MO United States  
works fine

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 good stuff Thursday, July 21, 2011
taco eater : Ryan from Allston, MA United States  
fit right on, no issues with stripping or anything of the sort.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Haters gonna hate Tuesday, January 4, 2011
taco eater : Deadped Ryan from Nashville  
Ok... so pretty much from now on, I will only tighten my cylinder to my judgement. I don't think that torque wrenches are accurate at that low of ft-lb measurements.

I just tighten these to a reasonable tightness with thread lock, and then tighten the head bolts the same way. No torque wrench on these. I have no air leaks either. Been using these for going on two months now with lots of removing and retightening (fooling around with cylinders) and they are solid.

Although, I feel like sometimes if I tighten too much, they'll sheer off.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Stripped at 6 ft/lbs Thursday, October 14, 2010
taco eater : Matt from Norman, OK United States  
These puppies stripped at HALF the required torque for my setup, causing a HUGE pain in the ass.

Was this review helpful to you?

  1 taco eaters like this review
 
1 of 5 Real bad Sunday, September 19, 2010
taco eater : Abe from PA  
My favorite feature of these studs is how at 7 lbs-foot the threads shear off the stud making dozens of tiny rings that function independently of the stud and one another.

Was this review helpful to you?

   
  Click to see more items