Return to puch moped front sprockets
 :
page of 1


  0 taco eaters like this review
 
2 of 5 Nice n cheap Saturday, May 30, 2026
taco eater : Anonymous Person from United States  
Like the other guy said they fit loosely and are thinner than oem.
If treatland got more of the A+ big sizes I would get one in a heartbeat.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Saul good Saturday, November 27, 2021
taco eater : Moped Madman from Murrieta, CA  
It works, nothing magical, the A+ quality fit a little better but its only a peice of metal with teeth, save ten bucks and dont let it bite ya when your throwing it on

Was this review helpful to you?

  1 taco eaters like this review
 
2 of 5 Loosey Goosey Wednesday, July 15, 2020
taco eater : Matt B from Troy, NY United States  
The stock front sprocket is nice and tight fitting, the more expensive ones are nice and tight fitting, these are loose, with lots of play back and forth and maybe are a bit thinner so the retaining clip rotates freely while its on, its probably fine but it will cause more wear to the spline because of this, its just a fact... low tolerances

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 For the 18 tooth Friday, May 27, 2016
taco eater : Countryobtunning from Princeton , MA United States  
Make your Dremel and file your best friend. Took me about 20 mins to slap it on a modern 3 bearing case. I got scared, I though I went to deep but it end up being a threaded hole for a magneto screw thank god!

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 yesssss Sunday, March 6, 2016
taco eater : daev o. from Providence , RI United States  
slapped a 17t on my e50 mag and it went on in less than 2 mins. weighed about same as stock 16t. and when I paired it with 41t rear OHHH NOOOO so fast its scary.... buy this and enjoy!

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Too big for an e50 Friday, January 29, 2016
taco eater : Wesley Brown from Austin, TX United States  
I couldn't get the 18 to fit on an e50 even after grinding down the case.  Build quality is pretty killer though.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Sprocket ROcket!! Thursday, November 7, 2013
taco eater : James Bond from Los Angeles, CA United States  
Change your gearing to tune your torque and top speed. Its shiny and new!!!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 perfect fit Saturday, December 8, 2012
taco eater : mmcc from sioux falls, sd  
yup, perfect fit.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 got me a 17 tooth Wednesday, November 21, 2012
taco eater : Brian Scarborough from coral springs, FL United States  
its heavy duty.   brand new teeth not all chewed up like your stock gears are...   wonder why your chain hates you ?  its because your makin it run on worn out gears bro.    get a fresh gear and have a happy long chain life.

ps - the 17 tooth i got is heavy.  like weight. its a solid disk with no holes in it , so  i plan to lighten. drill  it up a little before i slap it on to run.

Was this review helpful to you?