Return to puch maxi front fender mud flap SET
 :
page of 1


  0 taco eaters like this review
 
3 of 5 Had to clip the outer nibs Friday, June 28, 2019
taco eater : Tina from Bloomington, IN United States  
The smaller one that comes with it fits perfect, but this big guy pictured required some creativity with and x-acto and super glue

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 puch maxi front fender mud flap Monday, December 24, 2018
taco eater : Erik Barney from Yelm, WA United States  
don't fit on my 1980 maxi front.
Fits on rear.....

Was this review helpful to you?

  1 taco eaters like this review
 
1 of 5 dont fit Monday, May 21, 2018
taco eater : Keith Char from Honolulu, HI United States  
Don't fit!

Edit treats : on what?

Was this review helpful to you?

  2 taco eaters like this review
 
2 of 5 HARD TO INSTALL Wednesday, August 27, 2014
taco eater : Walter Perine from Wellington, FL United States  
It was very hard to stretch the mud flap to index the rubber pins into the holes of my 1981 Maxi-Luxe front fender. I tried everything including heating up the rubber. Finally I cut off the pins and drillled four small holes, and installed 8/32 bolts and lock nuts. I really think there is a design flaw in the part. BTW The front small rubber finisher that comes with the flap fit perfectly. I also noticed that on the original installation of the rubber pins they melted the ends to keep them from coming loose. I bet they were made from a different material.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Works as it should Tuesday, February 4, 2014
taco eater : Black Francis from atlanta, GA United States  
Get some speed nuts or star washers for the inside of the fender - the mud guard'll stay put

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Looks and feels good but doesn't fit too well: Tuesday, August 28, 2012
taco eater : Anonymous Person from Oakland, CA United States  
The rubber puts are a pain to stretch to fit into the holes in the fender and keep popping out. Maybe use some glue?

Was this review helpful to you?