Return to puch 38mm O-RING high compression head
 :
page of 1


  0 taco eaters like this review
 
1 of 5 Doesnt work with treat kit Friday, May 13, 2016
taco eater : Edgar Massey from El Cajon, CA United States  
I put this on the treat kit v1 and it blew first ride, but I can use my tomos head without a gasket and its fine so... Don't use with treatland kit.

Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 Uuummmmm.... Sunday, November 29, 2015
taco eater : Daevy O. from Providence , RI United States  
Fits great on my stock e50 with biturbo pipe torqued to 7pds. Love the oring however three star rating cause it was not bolt and go.... Because of compression head my bike has run VERY HOT. Upjet and it 4 strokes.... Very frustrating as it totally gives me the low end I was looking for.... The only options I've heard from moped army are jetting which is def dialed (not my first rodeo) and retarding my timing .... Why!!!!!!! Still a nice head and may work for some... But if I had to do it again wouldnt buy as I was looking for an easy fix for low end. Any suggestions would be great! Or I'll be selling on cl and giving the hi comp a try.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 fits on a55 Thursday, March 26, 2015
taco eater : Christopher Stawski from Montreal, QC Canada  
Head is slightly smaller then an a55 head, however it still fits nicely. Super high compression and no more damn leaky gaskets.

Ring OD is 51.5 mm

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 oring Thursday, March 12, 2015
taco eater : Tom King from Central Point, OR United States  
oring needs be high heat    red or org

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Yikes Monday, September 30, 2013
taco eater : Mark from Rochester, MN United States  
Put this on mine Tomos Targa A35 in 5 minutes, and the 0-ring was blew in less than that riding. Had to order  a new ring and hope that it doesn't happen again (only a 1.50 so not too bad its only the time). it is considerably smaller then the Tomos block and is not black to match but I really like the look of it for some reason. i thin it gave me more low and power and with the techno circuit pipe i have low to high end. It turns out the stock Tomos Block flat surface is not a large enough diameter to match the space needed by the flat surface of the O-ring. Mine is only 1 mm off and that is why they kept blowing out!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 good product. Saturday, September 7, 2013
taco eater : Nate Cassel from Glendale, AZ United States  
If you are looking for a good H.C head for your stock maxi pinto or swinger, look no further. A blindfolded baby on heroin could install with basic tools. just dont over torque! torque spec on my pinto is 7ft lbs for the head bolts. installed head in under 5 minutes and blasted away.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 hi hi compression Friday, October 12, 2012
taco eater : conor boone from Lexington, KY United States  
put this on my stock cylinder and got my low end back

Was this review helpful to you?