Return to polini variator plate guides
 :
page of 1


  2 taco eaters like this review
 
5 of 5 Good Quality Monday, June 12, 2017
taco eater : Matthew Hudak from Granger, IN United States  
I used them on the tjt and they work wonderfully! Yea there's some sanding, but hey no one ever said building a moped wasn't going to involve a little work ya dirty lazy 2 strokin bastard. Get your dremel out and save some time smart guy.

Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 Needs modification on hobbit tjt Saturday, October 8, 2016
taco eater : roger suarez from Orlando, FL United States  
They are short and thick. Takes a lot of filing and sanding.  To bad I lost the tjt ones.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Make your race variator almost bullet proof Thursday, March 31, 2016
taco eater : Kymco ZX50 from Stonington, CT United States  
These are the best guides Iv ever used. They are heaver/more material and you need to make sure you install them the correct way. The wrong way will not let the variator close all the way. Assemble without rollers to figure out the correct way. Then ride like you stole it.

Was this review helpful to you?

  2 taco eaters like this review
 
4 of 5 Don't file them like a little bitch Thursday, September 17, 2015
taco eater : AC from Ann Arbor  
cut them to size with a razor blade like a man.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 part no Monday, July 14, 2014
taco eater : rg from East Bernstadt, KY United States  
didnt see this before it just got put on here.  i was gonig to put the part no of this so you could compare cause i took a guess with the variators it fit, since htey used the 16x13 roller weights and i went theyll probbaly use my same guides as my variator uses those slides.  and they'll fit.  well they fit.  and the part no was 242.029.  they probably just looked it up when i ordered to put the part number.  these guides work fine and remember, the ramps, stick, out.  the big part of the slides, goes down.  where theres more room.  on the inside of the variator.  they pad it from the ramp, hitting on the back of it.  or youll hear your variator sound like a cannon and go boom from it busting

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 tjt Thursday, August 11, 2011
taco eater : Dominic Valentino from CLE  
had to file quite a bit to not bind on the hobbit tjt

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Works with Honda hobbit Sunday, October 3, 2010
taco eater : Easy E. from Louisville, KY United States  
Works on honda hobbit variator.  Had to tap in place with a hammer but seems to work fine.

Was this review helpful to you?

  2 taco eaters like this review
 
4 of 5 Worked on a stock Derbi variator Thursday, July 15, 2010
taco eater : Mars from Cambridge, MA United States  
Yes, they worked on a stock Pyramid reed variator.

Was this review helpful to you?