Return to MLM yamaha QT50 vm18 clamp style intake
 :
page of 1


  0 taco eaters like this review
 
4 of 5 CHECK CLEARANCE Tuesday, August 15, 2023
taco eater : Billy L. from Dunedin, FL United States  
Check the clearance on the manifold !

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Requires some hand finishing Tuesday, August 7, 2018
taco eater : Anonymous Person from ME, United States  
Paint bubbles and skid marks all over the mating surface! expected better fit and finish from MLM

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Fits PW50 with minor modification Thursday, October 26, 2017
taco eater : keith C from Albany, NY  
This intake lines up and fits on a Yamaha PW50 motor after a few minor seconds with a dremmel . The front of the intake hit part of the motor mount on the left side just enough to make it not line up(it may not hit on yours) .   You  would need a 45/90degree boot to have a 19-21MM PHBG to clear the frame

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 Chuck the stocker Saturday, September 27, 2014
taco eater : Anonymous Person from visalia, CA United States  
Intake is made well and will not choke off air supply like a stock qt manifold. I use a KN RU-0100 air filter you can look it up on their sight. It is 4 inches long and has a 20 degree angle on the rubber boot.What you do is pull your kick starter off the shaft then move the shaft clockwise or downward till it is positioned at about 2:30 looking at a clock.Slide it back on the shaft then put your kn filter on angled up.The kick starter will fold nicely under the filter and you still have plenty of lever movement going down.You can also use KN-0110 which has the angled boot but is five inches long instead of four.Looks good too

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 excellent product Wednesday, July 30, 2014
taco eater : matt boda1nz from des moines, IA United States  
very well made, fits like a glove to the engine and to the vm18. no leaks.. so nice.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 looks..10...dance...TBD Wednesday, April 23, 2014
taco eater : michael niewinski from ballston lake, NY United States  
looks very cool,fits nice...test run later

Was this review helpful to you?