Return to moped spark plug tool BLACK!
 :
page of 1


  0 taco eaters like this review
 
4 of 5 Moby/ ngk sparkplug Wednesday, June 19, 2024
taco eater : I don't have an id from Sticky  
Good: slips over spark plug in tight Frenchie spacing, has some neat notches. Short length fits super nice in tool stash box on Mobys

Bad: 22mm hex on spark plug side (2mm bigger than ngk br*hs) + thick boy design = busted head fins. Short length = no leverage.

14mm bonus hex true to size

Gets job done

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 it works great for plugs and bowls! BUT... Thursday, August 17, 2023
taco eater : Bore Lort from FAHMINGTON, NH United States  
i personally ground the end screwdriver off mine after not one but two lacerations to my palm when adding leverage on the end when hot plug lets go. just be careful, or neuter it.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 I THINK YOU MEAN 'BLK' Thursday, May 28, 2020
taco eater : Mike Boyd from Los Angeles, CA United States  
Best tool ever made for Puch mopeds / bing riders. I have accumulated like 6-7 over the years and I still want more. Put em in rally packs if your gang is the realest. Wear em on your carabiner so other nerds know what hobby you claim.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 More!!! Sunday, March 27, 2016
taco eater : Bob Hansen from Portland, OR United States  
Love this tool and lost my last one!
When are we going to get more of these?!?!!!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Totally Rocking! Tuesday, August 28, 2012
taco eater : Anonymous Person from Oakland, CA United States  
Yay!

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 yes. Wednesday, March 16, 2011
taco eater : d.o from salem ma  
This tool is ten times better than that piece of junk I found at autozone. That thin little thing bent first time I tried to use it. The hex on this tool is thick steel and isn't going to round out when you torque it. Lightweight, sturdy, and has two screwdrivers, buy it.

At first it didn't fit between the plug and upper bolt mount on my garelli vip. A few minutes at the bench grinder fixed that. You have to grind down the edge around the hex where it is welded, pretty much flush with the hex.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 handiest of handythings! Monday, September 20, 2010
taco eater : Anonymous Person from Norman, OK United States  
Ive used this more than any other tool in my secret compartment...

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 amazing Thursday, April 29, 2010
taco eater : Conrad from Grand Junction, CO United States  
This thing is so handy to have. Easy to use and fits in tight spots like on motobecanes.

You can clip it on your carabiner and be cool!

The small side for bing float bowls works pretty well too. Use a screwdriver for taking out jets. The tool will work too, but sometimes it doesn't fit.

Was this review helpful to you?