Return to malossi scooter clutch springs set - MHR delta / fly clutch
 :
page of 1


  0 taco eaters like this review
 
5 of 5 Strongest available Friday, February 26, 2021
taco eater : JBOT from El Cerrito, CA United States  
Tricks for hobbit.
Remove rubber pieces on clutch. Throw away. Then take arms off hub. Springs then placed on arms. Then put arms  back on posts.
Without the rubber bits the clutch will engage so much harder and the posts won’t bend.



Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Broke my hands installing them Thursday, August 24, 2017
taco eater : Evan Drew from Las Vegas, NV United States  
Haven't even tried these yet but I know it's gonna be insane, they are basically impossible to put on a hobbit clutch but after about 45 min of wrestling I got the blues on, might not even be possible to put the blacks on tbh

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 springs and install Sunday, April 6, 2014
taco eater : George Warren from Castro Valley, CA United States  
I found an easy way to install springs is to,leave the clutch tool on the clutch and put the assembly in a a vise. put a big rod or screwdriver in the center and use a small stiff screwdriver to pivot the springs on the shoes using the center rod as a pivot. Hope it works for you. Definetly better take off!

Was this review helpful to you?

  3 taco eaters like this review
 
5 of 5 warning. Saturday, June 23, 2012
taco eater : Ryan Nash from Columbia, MO United States  
prepare for face melting rpm's ... ok so that's the good and here's the bad... all of these --- ESPECIALLY the blacks are EXTREMELY HARD if not impossible to put on a derbi or hobbit clutch... they are just too small.  we managed to put the reds on a DR kitted hobbit... it's crazy!!  they also wear down on the holes that the springs hook into after prolonged use.  just be careful.

reds = 4500ish
blues = 6500ish
blacks = 8000ish

get ready to tear it up.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 Um...yeah. Sunday, October 2, 2011
taco eater : X from youngstown, OH United States  
ShaneB is on the money. Put these on my high perf setup and it literally woke my low end up.

Was this review helpful to you?

  3 taco eaters like this review
 
5 of 5 Need insane revs before engagement? Buy these. Friday, April 22, 2011
taco eater : ShaneB from Michigan  
When you need your clutch to spin out realllly high for your high-RPM pipe, you pretty much need these. The launch will want to send you ass over teakettle and pretty much puts the fear of god into you, so be careful. Probably not suited for any pansy setup, but you wouldn't be paying $25+ for springs if you had a pansy setup, would you?

And honestly these aren't so bad to get on if you use the right tools and techniques.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Hobbit user Saturday, April 9, 2011
taco eater : Kyle Wagner from Menomonie, WI United States  
Dont  buy these for a hobbit, it is to much, the weakest of the bunch barely grab at the height of the rev the motor can take.

Was this review helpful to you?