Return to front sprocket for honda MB5
 :
page of 1


  0 taco eaters like this review
 
5 of 5 Will fit Derbi/Senda GPR50R Thursday, April 23, 2020
taco eater : Anonymous Person from Blountville, TN United States  
16t sprocket will fit ebs050/Senda motors. Put one on my 03 GPR50R. bolt holes are one off as others stated but throw a circlip on the shaft and it works just fine.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 gain some mph Saturday, May 18, 2019
taco eater : Conan Segar from Murrells Inlet, SC United States  
both the 12 and 14 bolted right up to multiple mb5s with no issues. 14-42 gearing helps keep up really well 45+ traffic! great quality 1000+ miles on these already.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Works if you get a new retainer Wednesday, October 26, 2016
taco eater : JakeP from Pomona, CA United States  
I bought this for a Derbi Start 5 and ran in to the same problem that the MB5 guys did. BUT if you buy a retainer from an XR 80 everything locks up like it should.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 It works, it moped Monday, August 10, 2015
taco eater : Dirty30 Dillon from CT  
Sure, the holes are 90* out. I ground down the clip that came with the sprocket to make recess for the bolts, then bolted the sprocket to the clip. Sure, it's not perfect. But with red locktite my sprockets isn't going to pop off any time soon (or ever maybe).

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 13t worked for me. Monday, March 10, 2014
taco eater : Joe Peg from Portland , OR United States  
Worked fine. I needed a different clip but I had one that worked in the garage.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 12 Tooth doesn't fit MB5 Monday, September 16, 2013
taco eater : John Kiniston from Tucson, AZ United States  
I got a 12 tooth sprocket for my MB5 and the notches and bolt holes are off by a notch. I'm going to try to rig it using the clip that came with the kit and go without bolts but I'm uncertain if that will work.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 16T won't fit Derbi Revolution Tuesday, June 25, 2013
taco eater : j.kay.oh from Ithaca, NY United States  
Bolt holes on the 16T are one notch off, and won't align properly so the lock washer can hold the sprocket on the countershaft.

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 15t doesn't work with MB5 Wednesday, May 30, 2012
taco eater : josh besecker from shoreline, WA United States  
Yea... lame. I don't know about the others... but the 15t sprocket doesnt work with the MB5. The gear in the photo has 4 tapped holes allowing for 2 different mounting positions. The 15t only has 2 tapped holes allowing for one mounting position... and that one position doesn't lock onto the shaft... so if you were to run it... you would end up with a 15t ninja throwing star aimed at your ankles...

Was this review helpful to you?