Return to 16mm-ish honda hobbit pa50 clone carb
 :
page of 1


  0 taco eaters like this review
 
5 of 5 wabron james Tuesday, April 29, 2025
taco eater : splak from OH  
these rule, especially for $20. get fuckin 6 of them so when one starts leaking you can just throw it in the garbage and toss a new one on.

but no really these are the only clone carbs I've had any luck with. this thing has made my knobbit pretty rowdy.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Perfect Wednesday, October 25, 2023
taco eater : Grant Hauersperger from Delaware , OH United States  
I put a smaller jet in because mine is a stock 78 Hobbit, ran like a new one ! Didn’t have to adjust anything. Just a warning though, when I pulled the float bowl there was left over shavings in there, from the factory most likely. You would be wise to check this before installing.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Solid carb - and can't beat the price! Friday, June 3, 2022
taco eater : Fitz from Clawson, MI United States  
Spent hours fiddling with my OEM 1979 PA50I carb to no avail. But I saw this and $20 and 4 days later I'm zipping around again. It seems to run a little too rich so I'll need to pick up a smaller jet I think.

Was this review helpful to you?

  0 taco eaters like this review
 
2 of 5 Meh Monday, December 16, 2019
taco eater : E from NORTH ANDOVER, MA United States  
Mehhhhh idkkk, I guess it works and all but this guy ran a lot richer than an oem carb. Same jet, same setup: this carb was so rich bike wouldnt move, oem carb ripped. Again probably nothing wrong with this carb but I opted to use my oem carb over this one

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Question.... Friday, November 17, 2017
taco eater : Anonymous Person from Valdosta, GA United States  
Does this fix on a Honda Express?

Was this review helpful to you?

  8 taco eaters like this review
 
5 of 5 Attack of the Clones Friday, April 28, 2017
taco eater : DrGeorgeTompson from Washington, DC United States  
I like this carb cause it has an extra adjustment screw that I'm not entirely sure what it does. You see it there? on the opposite side of all the other adjusty bits? yeah that one!

It is a needle that i'm pretty sure goes into the emulsion tube or maybe chokes the amount of fuel getting fed into that left side hole when you look into the back of the carb. Is that choke fueling? beats me. who cares though, more adjustment is good.

Anyways, the finer things:

Mine came with no o-ring. Harbor Freight box of o-rings saves the day again.

The mentioned "not shown in the photo" drain line is about 40 feet long and melted on my proma in like 30 seconds cutting it to the proper length. A+

I would say the included jet is a 78.

Aluminum doesn't seem bad. I didn't break it yet and i made sure to hog dick the screws and nuts real good for science.

Had to scrape some casting defects out of the float bowl. no problem

With a name like Wabron, how could you not trust it?

Was this review helpful to you?