Return to puch moped E50 one speed full gasket set 50cc
 :
page of 1


  1 taco eaters like this review
 
4 of 5 And they gave free stickers January 22, 2018
taco eater : Michael Morrison from Columbus, OH United States  
Desert looking and they gave me stickers

Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 Mehh September 24, 2017
taco eater : Connor Winter  
Gaskets are thin and some are just a little to big to where it makes the gaskets fold,thus causing more air leaks. Same goes along with the float bowl fiber gasket. Hmmm not to bad of a price though.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 alright December 3, 2014
taco eater : Douglas Kelly from Red Bluff, CA United States  
i could have sworn last time this had round port intake gaskets.  hmmm... last time i needed rectangular, this time i needed round.   oh well...

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 mmmm October 1, 2012
taco eater : Walt E from Harrisburg, PA United States  
Always helpful to have a few of these laying around.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 much needed September 13, 2012
taco eater : jedadiah wessel from mpls, MN United States  
works great!

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 mostly good November 10, 2011
taco eater : Eric Cox from Columbia, MO United States  
some of the gaskets are thin, in some cases it won't matter much but I have had a hard time getting the intake to seal.

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Thin gaskets July 15, 2011
taco eater : MoCatz187 from Cincinnati  
The intake gasket and others are awfully thin.  I think I'll cut my own next time.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Most gaskets fit well March 20, 2010
taco eater : Jens Troest from San Diego, CA United States  
But the cylinder gasket did not fit very well, slightly blocking the transfer ports which is odd when I have a stock cylinder. Nothing that cant be fixed with some paper cutting skills though.

Was this review helpful to you?