Return to puch moped REAR sealed bearing axle - 12mm x 185mm
 :
page of 1


  1 taco eaters like this review
 
1 of 5 Doesn't fit April 21, 2021
taco eater : Eric from Portland, ME United States  
Supposed to fit stock puch spoke wheel assemblies. It doesn't. Maybe I was just unlucky?

edit treats : this an exact replica of the original puch sealed bearing rear axle. If it doesn't fit you are either trying to use this on a loose bearing wheel or ... not sure... but contact us for help of course if needed.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 seriously easy March 17, 2014
taco eater : Anonymous Person  
This is a whole lot better than goin to the harware store and looking for a big ass bolt and stacking some washers!

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 perfect for 5-stars February 26, 2014
taco eater : Onell from Winter park, FL United States  
Perfect Replacement for Puch rear 5-stars.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 perfecto on 103 rad 5 star baton wheels October 1, 2011
taco eater : a treat from treatlanderia  
ya know the peugeot 103 wheels that everyone wants? this works as a perfecto replacement for them if yours is crusty n tired.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Upgraded from 11mm on my Pacer SS May 13, 2011
taco eater : Zachary Kortz from East Lansing, MI United States  
Good quality axle. Used it on my Pacer SS along with 6201 bearings to upgrade for my fat ass.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 kinda tricky May 11, 2011
taco eater : Jordan Hanson from Mitchell, SD United States  
get urself an m12x1 bolt and use that for the spacer on the none brake side not the supplied spacer then use the bolt with the lip between the brake and bearing and use the other 2 bolts to tighten her down

Was this review helpful to you?

  4 taco eaters like this review
 
5 of 5 Conversions! July 12, 2010
taco eater : Patrick Sison from Chicago, IL United States  
These are perfect for your sealed bearing conversion needs.  Just beware you will need your dremel handy to hone out your old 11mm stuff: brake plates, tensioners, speedo drive.  And pick up some tubing for spacers.

Was this review helpful to you?