Return to CHROME pedal arm set for your moped and his and hers and mine too
 :
page of 1


  0 taco eaters like this review
 
5 of 5 Just Awesome August 6, 2021
taco eater : KH from Bermuda  
Want to bling out your Moby? This is perfect for you! Plenty of Clarance to get around that clutch! You need it!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Get these for Motobecane. Extra clearance! July 10, 2020
taco eater : anon from spaceship earth  
Pretty much every Motobecane 50v I have ever seen has a scratched variator because of the awful original pedal arms grinding against the variator. These fine chrome pedal arms give the variator enough room to breathe. These are the pedal arms that Motobecane should have made. No modification was required to make these fit perfect on a Motobecane 50v.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 5 tacos cuz chrome September 14, 2016
taco eater : davenporker from Toledo, OH United States  
Yes. I spent 45 minutes with an angle grinder and bench grinder to get it to fit smoothly on my V1A, but they look great and the chrome withstood the heat very nicely.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Nice! November 11, 2015
taco eater : Anonymous Person from Rochester, MI United States  
Super nice, NO fitment issues of any kind for my Magnum XK.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Had to cut to fit, but looks dope! December 2, 2014
taco eater : Matt from Boulder, Colorado  
Had to cut about 4-5mm off one the arms to make it fit on my Honda Hobbit. But it was well worth it because now I have pedals, yay!

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Grind to fit V1. May 18, 2014
taco eater : MennoOonneM from San Diego, CA United States  
These are a bit fat around the pedal shaft end to properly fit a V1 motor on the clutch side. You'll need to use your bench grinder to get a good fit.

Really well made though! Good pedal threads!

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Smaller cotter pin July 29, 2013
taco eater : Andy Felty from Dallas, TX United States  
I got the 9.5 pins and one side went in perfect the other not so much, don't count on being able to get the cotter pin back out after you smash the crap out of it either, ended up having to cut my crank off completely... Good quality arm though, chrome was nice too

Was this review helpful to you?