puch 19mm PHBG intake - SQUARE port
puch 19mm PHBG intake - SQUARE port
 



  $16.00

 :HERE NOW!!
qty:

 
 
clamp style 19mm intake for puch piston port cylinders. this is square port on the bottom perfect for the 50cc and 70cc treat kits. also if you have a metra you can use this but you might want to match the circle to the square with a dremel. lots of people don't and they are fine, but there's some performance to be found through a nice match. if you want to use this with the rubber mount style it will not be fun, not enough room. this is for E50, but you can use it on a ZA50 however your carb will be at a slight angle, no prob as phbgs are designed with angles in mind. in some cases on ZA50 you may have to dremel down the oil injector hump, this tends to be more of an issue on metra than other kits. ideally you will use this on an E50.

19mm - ID
24mm - OD

taco rating taco rating 3 of 5 3 of 5 Total Reviews: 5 give your taco rating here

  0 taco eaters like this review
 
4 of 5 pretty nice intake for 70cc athena kit February 25, 2018
taco eater : michael kuriger from Santa Clarita, CA United States  
The inside needs to be finished with a dremel, lots of machining imperfections inside.  To fit my 19mm dellorto carb, I had to remove the little air vent to get the carb to fit against the puch frame.  
I actually like the "round hole" angled intake a little better although if you want to use the plastic engine cover you'll need this one.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 So tight January 29, 2016
taco eater : Wesley Brown from Austin, TX United States  
Would have been nice if they could have angled it a bit more away from the engine but if you put the carb on first then mount it to the engine it installs fine.

Was this review helpful to you?

  1 taco eaters like this review
 
1 of 5 You've been warned September 23, 2013
taco eater : Anonymous Person from CO  
Like the other guy said, it won't clear a pinto frame without work.

Was this review helpful to you?

  1 taco eaters like this review
 
3 of 5 fitment issues March 4, 2012
taco eater : Anonymous Person from Detroit, MI United States  
the carb wont clear the frame on my swinger unless i mill down the mating surface on the intake... other than that this thing looks pretty well made.

Was this review helpful to you?

  2 taco eaters like this review
 
3 of 5 should get the job done on your 19mm phbg January 25, 2012
taco eater : Nicholas Badman from Dover, DE United States  
Ideal fit for a dellorto PHBG 19mm clamp style carb. I would use it on my puch but just got a new k star cylinder party pack. Going 70cc woop woop.

Was this review helpful to you?