puch super stiffy clutch spring for all puch E50 clutches
puch E50 clutch spring
 



  $3.50

 :HERE NOW!!
qty:

 
 
for puch E50 clutches. hi tension race clutch spring for E50 clutches. These are the stiffest we have!

these are made for the puch kick start clutches and work with all puch E50 clutches, 3 shoe, 2 shoe, kick start, performance, stock. .

THESE ARE SOLD BY THE PIECE, I.E. you get ONE if you buy ONE.

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 6 give your taco rating here

  1 taco eaters like this review
 
5 of 5 LISTEN TO KEN ROFF May 7, 2015
taco eater : Quoc Le from Manchester, NH United States  
stock two shoe clutch. 2 of these bad boys. turn in 2-3 times (personal preference) and blast!

if you're scared that your clutch will get bent, then get yourself a brace... or make one you big dummy!

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Good Springs September 12, 2013
taco eater : Elliot Craig from Raleigh, NC United States  
Ran them on a stock 2 shoe for 4-6 months and they're amazing. about to throw them on a new 3 shoe with a 50cc kit, just don't over tighten or you will warp your shoes/ eat your shoes away. Make sure you take your time when tuning and only turning in ever so much, sucks but it will save you problems in the long run.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Work Great February 14, 2011
taco eater : John from Tucson  
These work great on my E50.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Make your 2 shoe REVVVVVVV February 14, 2011
taco eater : Zach Raddatz from Lincoln, NE United States  
Perfect for a lightened 2 shoe... MUST use a brace. Will bend the posts otherwise! I have 1000 miles on my stock shoes so far and there holding good!

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 better have power September 9, 2010
taco eater : Maize from Minneapolis, MN United States  
works great with a three shoe, but you have to have power, my clutch would not grab until 8000 rpm, so the bike was a race bike. clutches would burn out in 1 day and the clutch plate pivot arms would be bent out.

i love them. use them with a brace!

Was this review helpful to you?

View All Customer Reviews