derbi flatreed & piston port + morini m1/m01 + tomos pedal crank seal - 16 x 24 x 5
derbi flatreed & piston port + morini m1/m01 + tomos pedal crank seal - 16 x 24 x 5
 
  $5.99

 :HERE NOW!!

qty:

 
 
derbi flatreed & piston port + morini m1/m01 + tomos pedal crank seal

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Garelli VIP pedal shaft June 30, 2016
taco eater : Anonymous Person from USA USA USA!  
Grab a couple of these if you want replace the pedal shaft seals on your Garelli VIP

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Actually, these are the right seals! January 11, 2012
taco eater : Will Caldwell from Derbiham, WA United States  
At least for my '80 piston port variant motor! The original seals are 16x24x4 but those are hard to come by and the extra mm of width doesn't matter because it'll just stick out from the cases a lil bit. no biggie!

-jesse could you post what size seals yours has? it's a lot more helpful than just saying they don't fit.

1980 piston port seals for me
2 - 17x28x6 single lip crankshaft seals (replaced with double lip seals cause that's what was available)
2 - 16x24x4 single lip (or 5mm doesn't matter) pedal shaft seals (again these were replaced by double lip seals because they were what was available locally)
1 - 15x30x7 single lip sprocket shaft seal
1 - 25x40x7 double lip DOUBLE SPRING rear pulley shaft seal (i replaced this with a double lip single spring seal...shouldn't be a problem but we'll find out!)

hope this helps out all the derbi kids rebuilding early piston port motors

Was this review helpful to you?

  0 taco eaters like this review
 
1 of 5 Wrong seals for PP November 27, 2011
taco eater : Jesse-B from Fort Myers, FL  
These are the wrong seals for piston port motors. i have three different motors and none of them have these seals.

Was this review helpful to you?