taco eater :
Matthew Mulligan from terryville, CT United States
Head was weird out of the box, casting texture in combustion chamber and weird sharp angles, so I polished it up a bit. Otherwise just matched transfers and polished the exhaust port a bit. Geared 27/24 on a streetmate with a 3" knobby, phva 17.5, 18mm intake and estoril sidebleed. Honestly, my ported stock cylinder was faster. I gained low and mid range and have better hill climbing, but I had to swap rear sprocket from 26 to 24 to gain my top speed of 44-45 back and it's much weaker on top.
Update: still 3 stars because that head is weird but I found a massive oil leak at the case gasket and suspect an airleak, will update review again upon rebuild.
Was this review helpful to you?
1 taco eaters like this review
Beautiful Engine
February 16, 2023
taco eater :
Nelson from Wise, VA United States
As far as installation it has been a breeze, still haven't had a chance to run it, will provide and updated review later.
Was this review helpful to you?
2 taco eaters like this review
This is Hot Sauce you need
April 27, 2020
taco eater :
Enchilados from Grand Rapds, MI United States
This kit installed perfectly in 2011 Streetmate with stock exhaust, intake and carb. 22 tooth sprocket added next. Moded muffler for fun but was not enough. MLM sidebleed added and bam, now stock carb is limiting the good times(speed 44gps). 18mm Mikuni kit is on the way...
Was this review helpful to you?
0 taco eaters like this review
?
October 4, 2017
taco eater :
william from wilmington, NC United States
Will this work on an 86 a3
Was this review helpful to you?
3 taco eaters like this review
MOPED RIPPAGE
September 16, 2017
taco eater :
B doorn from Long valley, NJ United States
This kit is Most definitely the best drop in kit ever...opened up the transfers a bit and Woah hold on! With the kit, 19mm phbg, Treatland hammer clutch, homoet p6 and 28/22 gearing I get as high as 58mph with good acceleration on my streetmate R
Meh (maybe) 
Beautiful Engine