POLINI puch ZA50 + tomos A55 A35 A3 + minarelli V1 + morini - crankshaft seal - 17 x 35 x 7

POLINI crankshaft seal 17x35x7
 
  $12.99

 :HERE NOW!!

qty:

 
 
they are perfectly interchangeable to the original ones, and they can be fitted both on the crankshaft and on the CVT's primary gear. they are made of FKM (fluorocarbon rubber) to better resist to the highest termic stress; the seal lip is made of PTFE (polytetrafluoroethylene); this feature makes them a lot more durable than the standard original ones, giving them a smaller friction coefficient thus granting less heat dispersions caused by the friction and at the same time maintaining lower temperatures. these oils seals have been studied with racing engines but equally they perfectly fit on the standard engines that haven't been tuned-up. more power is produced from the engine as the friction reduction allows it to reach higher revolutions ranges.

1. steel core
2. steel spring
3. blue FKM body
4. brown co-pressed PFTE

teflon and viton oil seals

polini crankshaft seal for puch ZA50 (magneto side), tomos A55 A35 A3 engines, minarelli V1 & morini M1/MO1.

17 x 35 x 7

polini part number 285.0136

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Good stuff. Polini! April 15, 2016
taco eater : Charles Brown from Eustis, FL United States  
Put one on my stator side on my Targa. Will put the other one I bought on the tranny side when I have to open it up again.
So far so good.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 butterr April 29, 2014
taco eater : will caldwell from san francisco, CA United States  
installed these on a start V revolution motor. really nice seals with SUPER low friction. after assembling the cases and installing these seals, the crank turns over like butter....almost no friction. coool

Was this review helpful to you?