 |
 |
 |
|
new old stock vespa piaggio ALFAERRE 41mm kit! almost identical to the discontinued polini 41mm kit and is a verified super ripper!
comes with cylinder, piston, two rings, wrist pin, clips, base gasket and sticker.
drop this in your stock case with only port matching to complete. seriously rad, no case boring. bolt and go. i bet you can use your stock head! or grab a polini 43mm head!
10mm wrist pin size! be sure to MEASURE before ya buy!
"yeah, this kit hauls ass. i had mine on completely unaltered stock cases
with a mazzucchelli anticipato crank, 12:12 and giannelli fire pipe.
single speed setup with an 80mm rear pulley was ripping my ciao up to
47-48+ mph.
i've ran the 43mm polini before, which is indentical
port-wise to the 41...the 41mm is just as fast as the 43, except you
don't have to worry about the skirt cracking cause it's much thicker.
55cc's is all ya need"
vespa mopeds - bravo, grande, si, kinetic, tfr - this will fit on any of these!
|
|
|
 |
|
 |
|
