MLM puch water cooled head - 45mm - treat REED

MLM puch water cooled head - 45mm - treat REED - countersunk - O RING

MLM puch water cooled head - 45mm - treat REED - O RING

$149.99

alternate reality price $109.00

:*sorry none today*

qty:

here's what ya get in this PARTYYY!:

2 of 90 deg water fitting FLANGE BOLT ($3.98 value!)
1 of replacement VITON o-ring for 38mm - 45mm heads ($1.99 value!)
1 of MLM puch water cooled head - 45mm - treat REED - countersunk - O RING ($149.99 value!)
1 of round LC head puch 001 ($149.99 value!)
2 of water spigot for lc heads - 90 degree ($40.00 value!)
2 of water spigot o-ring - LARGE ($2.00 value!)
2 of water spigot o-ring - SMALL ($2.00 value!)

good evening passengers, this is your captain speaking. up ahead in the stratosphere is a USA-made, NASA inspired water cooled head specifically made for the puch 45mm 70cc reed kit especiale!!

buckle up amigo, time to blastoff to the future!!!

features:

- one piece design, 100% sealed against seam leaks
- bolt on fittings with perfectly matching o-rings on each side
- fittings have 360 free range of motion, ready to be bolted down to your desired angle! comes with 2 bolts.
- uses normal bhs plugs
- this head is the o-ring head style. the dome is perfectly matched for the kit as well. includes the head o-ring gasket.
- countersunk with the same design as this much loved air cooled version.

you WILL have to use LONGER cylinder studs. gotta go from m6 x 106mm (which is stock) to around 126mm or longer! basically you need 20mm more than the stock studs.

alternately, you could use the minarelli m6 x 136mm studs and some m6 spacers to fill in the extra stud length.

the head itself has a 113mm diameter. bolt holes are made for m6, but actually accommodate m7 as well, although it is a very tight fit. might be for the better, though, if desired.

fittings are 16mm OD, 15mm ID.

Please note when installing the fittings you should position the fitting in the direction you desire it to go and then tighten down the bolt. If you attempt to tighten down the fitting and then turn it the seal will be twisted and will possibly not seal. Make sure you follow these instructions carefully!!!!

here is a replacement head o-ring!

head diameter is about 114mm and about 28.5mm wide.

bolt hole pattern is about 44mm x 44mm. do NOT attempt to widen holes, it will go through the surface! most likely like 99%

water cooled isnt for everyone. make sure you have enough experience before you DIVE in (hahaha i crack myself up)

anyway, this thing is seriously sick. just about as flawless as it can get. MIGHT have a few tiny little pits in one of the fins, but basically perfecto!

enjoy your journey into uncharted territories. just make sure one day, you can amaze your friends and tell them:

"IT RUN ON WATER!!"

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 1 give your taco rating here

0 taco eaters like this review

Really rad, but...	July 16, 2018
taco eater : Brad Hale from Ypsilanti , MI United States

You'd think this would fit another certain 45mm kit that needs extra spacing (AJH split port) but sadly it does not. The kit's bore is slightly smaller, so the countersunk portion does not fit inside like it should. Still definitely going to get the other one and run it though.

Was this review helpful to you?

treatland