MLM puch intake for the COOL reed block - 21mm
MLM puch intake for the COOL reed block - 21mm
 



  $59.99

 :HERE NOW!!

qty:

 
 
YES! here is an intake for the DIO reed block bolt spacing - meaning you can bolt it to the cool performance reed block for puch polini and treat reed!!!

this is designed for use on those kits on a puch maxi / magnum, but feel free to get creative (and lucky) if it fits something else that uses the dio bolt hole spacing

21mm for phbg and any other 21mm youd like! these are for rubber mount carbs only, they will not work for clamp mount.

its about 52 x 42mm center to center of mounting holes, lengthwise and widthwise.

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  1 taco eaters like this review
 
4 of 5 Great fit, looks wow, needs porting for max flow December 15, 2022
taco eater : Jeremy Thurston from Stamford, lincolnshire United Kingdom  
Sits the carburettor around the chrome side bar area of a Maxi S. You can just about run the throttle cable inside the bar and choke cable (if you have one) outside it.
There is a step where the inlet 'tube' meets the flat plate, ideally this needs grinding to match the inside of the manifold to reduce any restriction.

Was this review helpful to you?